1. Open the battery compartment and install a 9V Alkiline
   battery by attaching the battery to the battery clips. Close the battery compartment.
2. Locate the Control Unit on the dash in a convenient location where the LED
   and sound transducer can be heard and seen.  Use the VELCRO strips
   that are provided.
3. Mount the Start Switch & Return Sensor to the Turn-Signal Lever using two of
   the ty-wraps.  Secure the switch itself in the proper position for use and
   then secure the wire to the Turn-Signal lever also with the other ty-wrap
   to provide some strain relief. See the picture below for the proper postion to mount the switch.
NOTE:  THE PROPER MOUNTING POSITION FOR THE START SWITH AND RETURN SENSOR IS CRITICAL FOR
   THE UNIT TO TURN OFF WHEN THE TURN-SIGNAL LEVER IS RETURNED TO THE NEUTRAL POSITION.
   THE START SWITCH AND RETURN SENSOR MUST BE MOUNTED TO THE VEHICLE TURN SIGNAL LEVER SO
   THAT THE TURN SIGNAL LEVER RETURN MOTION IS PARALLEL TO THE ARROWS AS SHOWN. 
4. Position the Mode Switch to the "LED + SOUND" position.
5. Push the tactile switch pushbutton while positioning the Turn-Signal Lever to either
   the Left or Right Turn position.  
6. You should hear the sound transucer "beep" and observe the LED flash.
7. Return the Turn-Signal Lever Switch to the neutral position.  The sound and beep
   should deactivate.
7a.  Repeat Step 5 & 6 and push the tactile switch pushbutton again.
      The sound and beep should deactivate.
8. When the Mode Switch is in the "LED ONLY" position, no sound will be heard. 

 
BACK